Home » Products » GQ50A 6-48mm Stainless Rebar Cut Machine

GQ50A 6-48mm Stainless Rebar Cut Machine

Compared with other cutting equipment, the steel cutting machine has the characteristics of light weight, low energy consumption, reliable operation and high efficiency. Therefore, in recent years, it has been widely used in mechanical processing and small rolling mills, and has been widely used in all areas of national economic construction.

Inquire Now << Previous Next >>

Product Application

Steel bar cutting machine mainly be used for cutting carbon steel reforce bar, hot rolled bar(HRB series rebar), round bar, square bar, flat bar, angle bar,also could easy operation or move to fit the project rebar process workshop needs.

Model

GQ50A

Cutting Capacity

6-48mm Carbon round bar

 

6-38mm II-graded deformed bar

Cutting Frequency

28 times/min

Input Voltage

380v,50hz,Three Phase(If different,the price will different.)

Power Of Motor

4kw

Machine Size

1400*480*850mm

Packing Size

1500*600*1050mm

Weight

520kg

 

Safty Operation 

1.Start runing about 10 minutes unload,it must stop instantly to check if find abnormal problems.It would operation

   as the following steps if all electric and every component good condition.

2.Open the blade cover,sent the reinforce rebar to the feed wheel to place what length you want.

3.Adjust the back gauge disk close to rebar.

   Notice:Subject to rebar could close to the fixed blade in parallel,using the wrench to fasten the nuts on it.

4.Adjust the block rod part close to rebar.

   Notice:Subject to rebar could close to the fixed blade in parallel,using the wrench to fasten the nuts on it.

5.Put down cutting blade cover,use the foot pedal or manual clutch to finish cutting rebar.

6.Straightening screw rebar cutter only could one rebar one time,it would tap the screw directly after cut.

7.Cutting work done,set off the power.

Get Price or Support

Hot Products
www.steelrebarcoupler.com

Copyright by steelrebarcoupler       Sitemap

Top